SKU: Roof-Aerial-AM-FM-DAB-GPS-5m Shark Fin Roof Mount Antenna AM FM GPS DAB 5m Cable

Roof Mount Shark-Fin Style Antenna AM / FM / GPS / DAB / DAB+

Roof mount aerial for a variety of vehicles; features DAB, AM, FM, GPS, ideal for digital car radios, shark fin style with the most common connectors.

Shark-fin style roof aerial.

General:

• Voltage: 12V DC direct feed for both DAB and AM/FM, usually sourced from radio remote trigger.
• Current Consumption: 50mA (approx.)
• No need to unscrew mast for car-wash.
• Can also be fitted to guards not exposed on the under side to the elements, boot lid etc. (please note this may affect performance).
• Vandal resistant
• Measurements base measures 8.46cm (length) x 5.41cm (widest point) approx. Bolt that goes through hole in car measures approx.1.4cm. Please check measurements before ordering thanks.

DAB:

• Frequency: 174MHz-240MHz (Band III)
• Impedance: 50 Ohm
• Amplification：20dB
• VSWR: ≤2.0:1
• Connector: SMB Female
• Cable: 5m RG174 (approx.)

GPS:

• Frequency: 1575.42MHz
• Impedance: 50 Ohm
• Amplification: 28±3db
• VSWR: ≤1.5:1
• Gain: 32dbi
• Connector: FAKRA C Female 
• Cable: 5m RG174 (approx.)

FM:

• Frequency: 87.5-108 MHz
• Impedance: 50 Ohm
• Amplification: 20dB
• VSWR: ≤2.5:1
• Connector: DIN Male
• Cable: 5m RG174 (approx.)

Shark-fin style roof aerial bottom.

Notes:

• Ensure that a water proof seal is obtained during installation. Professional installation is recommended.
• This aerial will provide reasonable FM reception and will pick up some AM; please keep in mind there is always a compromise when using a short antenna, you need a larger antenna for better clarity. Please see this listing.
• Mounting surface must be flat to within 1.5mm.
• Must not be mounted on a panel whose underside is exposed to the elements.
• Maximum mounting panel thickness: 2.5mm.

Shark-fin style roof aerial connectors.