SKU: V-5956-VOX200-Light VOX 200 Light Speaker Kit

Visaton Speaker Kit - VOX 200 Light
Art. No. 5956

Visaton VOX 200 Light - shown assembled with suggested cabinets, not supplied.

Characteristics and Sound Properties
Soon after its launch, the VOX 200 became one of the most popular and successful high-end kits. Several excellent tests in numerous specialist magazines have demonstrated that this system is at a quality level normally expected of far more expensive candidates. We were asked whether it was possible to fit these cabinets with much cheaper loudspeakers and still get good results.

At the lower frequency end, we replaced the AL 200 - 8 OHM with the W 200 S - 8 OHM and also took out the TI 100 - 8 OHM mid-range loudspeaker, replacing it with two W 100 S - 8 OHM. We left the G 20 SC - 8 OHM dome tweeter unchanged. Initial tests showed that only a slight adjustment to the crossover were required. In terms of sound quality, the modified VOX put up an excellent showing in comparisons with the original.

Technical Specifications

Frequency and Impedance Response

Frequency Response and Impedance Graph

Exploded Cabinet Drawing

Exploded Speaker Box Drawing

Assembly
At first sight, the construction of the VOX 200 LIGHT looks complicated, which is why it is worth looking at each internal part individually first. In the lower part of the cabinet, you can see the bass reflex tunnel, made up of the base, one horizontal and one vertical upper board. In the middle, there are two cross-reinforcements to prevent resonance. At the top of the cabinet, behind the cut-out in the acoustic baffle for the mid- to high-range unit, is the enclosure required for the mid-range cone, made up of two wooden boards. Three holes will have to be drilled in the rear wall of the mid-range chamber for the cables. These holes must be well sealed up at the end.

Fitting the W 200 S into the side is a special feature. Behind the square cut-outs in the side walls, the mounting board for the W 200 S is glued in place from within. This means that the bass driver can be sunken by 19 mm (19 mm = thickness of the boards). For optical reasons, and to enable the cloth-covered frame to be fitted exactly in place, the side-wall cut-out must be made extremely accurately. The frame can be made from a 12 mm board, in which a 205 mm diam. cut-out is made.

The outer dimensions of the frame should be 1 - 2 mm smaller than the opening in the side-wall all round. In this way, the frame is jammed in place by the fabric used to cover it and alternative fixing methods (wooden plugs) are not necessary. The frequency crossover unit is mounted on the side-wall behind the bass cut-out.

Internal Damping
The inner damping uses one mat placed inside the medium range cabinet. The remainder is evenly distributed throughout the cabinet. Only the space above the tunnel opening (to the rear of the baffle) up to the lowest stiffener remains empty. If, as a result of the acoustics in the room, the low-range bass is too powerful, it is possible to fill this space as well up to the tunnel opening to lower the bass power.

Component Parts List for Each Box - Supplied with Kit
The kit comes with all necessary components (see list below for one box), one set if the speaker is an each, or two sets for a pair, see price above for details.

Speaker Cabinet Material List to Make 1 Box - Not Supplied with Kit

Speaker Cabinet Dimensions

Loudspeaker Box Construction Diagram - all dimensions in mm.

Crossover - Supplied with Kit Already Assembled

Speaker Kit Crossover Circuit