Ford Falcon XK XL XM XP Under Dash 5x7 Inch Speaker 15 Ohm

Ford Falcon XK XL XM XP Under Dash 5x7 Inch 15 Ohm & 4 Ohm Speaker - Classic Falcon Restoration

Description
This 5 x 7" fullrange speaker is a faithful reproduction driver designed specifically for under-dash mounting in classic Ford Falcon XK, XL, XM, and XP models. Built with a 15 Ohm primary voice coil, it provides the correct electrical load required by original factory mono radios (such as vintage AWA or Bendix units requiring 15 to 16 Ohms). It also features an independent secondary 4 Ohm voice coil, allowing enthusiasts to connect a hidden modern Bluetooth receiver or auxiliary system to the same physical dashboard speaker without altering the original interior layout.

Technical Specifications:

• Application: Under-dash speaker replacement for classic Ford Falcon (XK, XL, XM, XP)
• Driver Format: 5 x 7" (127 x 178 mm approx.) oval fullrange mono driver
• Primary Voice Coil Impedance: 15 Ohm (for original factory radios requiring 15 to 16 Ohms)
• Secondary Voice Coil Impedance: 4 Ohm (for modern auxiliary or Bluetooth sources)
• Power Handling: 15 W
• Dust Cover: Black cloth
• Mounting Hole Pattern: 110 x 110 mm
• Baffle Cut-out: 118 x 170 mm (approx.)
• Mounting Depth: 50 mm (approx.)
• Total Height / Depth: 57 mm (approx.)
• Overall Length: 183 mm (approx.)
• Overall Width: 129 mm (inner frame) / 126 mm (across mounting tabs)
• Supplied As: Single unit (1 speaker)

Vehicle Compatibility & Dual Voice Coil Features:

• Original Radio Matching: Correct 15 Ohm impedance prevents overheating and output stage damage in vintage Ford factory radios.
• Factory Fitment: Designed to match original 5 x 7" under-dash mounting locations and factory bracket setups in early Falcon models (XK, XL, XM, and XP).
• Secondary 4 Ohm Auxiliary Input: Allows a discrete secondary modern audio source (such as a hidden Bluetooth module or modern 4 Ohm receiver) to drive the same speaker location without replacing the factory radio or modifying original dash panels.

Installation & Vehicle Fitment Warnings:

• Do NOT Combine Coils: Never connect the 15 Ohm and 4 Ohm voice coils together on the same channel or amplifier. They must remain completely separate circuits to prevent severe signal distortion and coil damage.
• Check Radio Impedance Requirement: Confirm your original radio specifies a 15 Ohm or 16 Ohm load before connecting to the primary coil. Standard modern 4 Ohm stereo radios must be connected to the 4 Ohm terminals only.
• Under-Dash Clearance Verification: Check under-dash space, wiper linkage movement, and bracket alignment prior to installation. Ensure depth (50 mm) and cut-out size (118 x 170 mm) match your Falcon's factory mounting area.
• Polarity & Grounding: Ensure correct wiring polarity when connecting to original vehicle speaker looms.