Your Cart (0)
Mundorf Fastening Clamp for Capacitors Diameter 40mm - MCNV40
Nylon plastic clamp for holding a 40mm diameter capacitor upright (vertical mounting). It is especially suitable for Mundorf capacitors, but can be used for other brands of the correct size. Integrated mounting holes let you fix the clamp to a board or panel, such as inside a speaker crossover.
Key Features
- Nylon plastic construction
- Holds a capacitor upright (vertical mounting)
- Integrated mounting holes for fixing to a board or panel
- Made for capacitors with a 40mm diameter body
- Suits Mundorf capacitors, and other brands if the body diameter is correct
Typical Uses
- Securing a larger capacitor in a speaker crossover
- Keeping a vertically mounted capacitor firmly in place, rather than relying on its leads alone
Specifications
- Part number: MCNV40
- Material: nylon plastic
- Dimensions: 40 x 25 mm (Ø x H mm approx.)
- Suits capacitor body diameter: 40mm
Installation Tips
- Fit the capacitor into the clamp before fixing the clamp down, so you can check it sits squarely and upright.
- Fix the clamp to a solid board or panel using the mounting holes, and do not over-tighten the screws, as this may stress the plastic.
- Leave enough room around the capacitor for its leads and wiring.
- It is advised to mount the capacitor and clamp first, then solder to ensure no extra strain is applied to the leads.
Check Before Ordering
- Measure the diameter of your capacitor body. This clamp is made for a 40mm diameter capacitor.
- Capacitor clamping nut and bolt is supplied; choose suitable fixings for the clamp to your board or panel.
- The capacitor itself is not included.
Please Note
Capacitor sizes vary between brands and ranges, so please check the fit.