Retractable Manual A Pillar AM FM Aerial

Retractable Manual A Pillar AM FM Antenna with 210cm Cable

Description:

A replacement manual aerial for A pillar mounting, with a three section telescopic mast. Ideal replacement AM / FM aerial for the Honda Accord and Civic, Mitsubishi, Mazda 323, Toyota Lift-back, Suzuki Swift and Suzuki Jimmy, and many other vehicles may be possible. It mounts with two screws, with variable hole positioning to suit different vehicles, and a rubberised seal keeps water out when installed correctly. Please check all dimensions to make sure the aerial suits your vehicle before ordering.

Key Features:

• Three Section Telescopic Mast: A 79cm manual mast that you extend and retract by hand.
• 210cm Cable: Supplied with a standard male DIN plug.
• Passive AM / FM: No power connection is needed.
• Two Screw Mounting: Variable mounting holes, to suit hole spacings from 54mm to 77mm.
• Rubber Seal: A rubber seal with several hole positions, to keep water out of the mounting.
• Cover and Hole Cap: A cover and a mounting hole cap give a neat finish.

Typical Uses:

• Replacing a broken, bent or missing A pillar aerial.
• Replacing a worn aerial that gives poor reception.
• Fitting an aerial that can be retracted when it is not in use.

Specifications:

• Mast length: 79cm
• Three section telescope
• Colour: Black
• Mounting hole spacing centre to centre: 54mm, 55mm, 60mm, 63mm, 72 to 77mm
• Depth: approx. 40cm (mast tube, inside the A pillar)
• Connector: standard male DIN
• Passive system, no power required
• AM / FM aerial (can be used with DAB radios with an optional splitter)
• Cable length: 210cm approx.

Supplied:

• 1 x aerial, with mast tube and base
• 210cm cable with standard male DIN plug
• Rubber seal
• 2 x screws
• Cover
• Mounting hole cap

Check Before Ordering:

• Check all dimensions to make sure the aerial suits your vehicle. Compare the hole spacing and position with your vehicle.
• Check that there is room in the A pillar for the mast tube (approx. 40cm).
• Check that your radio uses a standard DIN aerial socket. If it uses a different type, you will need an adaptor.
• This is an AM / FM aerial only. DAB radios can be used with an optional splitter.
• If you are not sure about your vehicle, please contact us to confirm before ordering.

Installation Guide:

• 1. Check the Fit: Compare the hole spacing and position with your vehicle, and check there is room in the A pillar for the mast tube (approx. 40cm). Remove any old aerial first.
• 2. Fit the Aerial: Feed the mast tube into the A pillar, and mount the aerial base with the rubber seal and the two screws, using the seal holes that match your hole spacing. Do not over tighten the screws, as the seal can deform.
• 3. Check the Seal: Check that the rubber seal sits flat, so the mounting is watertight, then fit the cover and the mounting hole cap.
• 4. Run the Cable: Run the cable to the radio, clear of sharp edges, heat and moving parts, and plug the DIN plug into the radio's aerial socket.
• 5. Test: Extend the mast, switch on, and check AM and FM reception. Retract the mast when it is not in use.

Important Notes:

• The rubber seal must be watertight when installed. Do not over tighten the screws, or the seal can deform. Check the seal after fitting.
• Make sure nothing is behind where the aerial and screws go.

Please Note:

• Professional installation is recommended. If installed incorrectly, damage to the unit or the vehicle can result.