Your Cart (0)
Black Replacement Mast for our acv Universal Electric Car Antenna Telescopic AM/FM
- Antenna telescopic rod
- Length: 80cm black
- Replacement mast specifically for our Universal Antenna
- This may fit other aerials, but we cannot guarantee this. We do not have any information on what else it may fit.
When you would need this
The mast is the thin section of the antenna, and it is the part most likely to need replacing over the life of the aerial. Common reasons include:
- The mast has been bent or kinked, often from a car wash brush, a low car park beam, a tree branch or garage door
- One or more of the telescopic sections has been snapped off or is missing
- The mast is corroded, pitted or sticking, so it extends and retracts unevenly or makes a grinding noise
- The chrome plating has worn, pitted or started to rust
- Poor or patchy radio reception where the aerial still motors up and down normally, which can point to a bent or damaged mast rather than a fault in the motor or the lead-in cable
If the aerial does not move at all, or only strains and clicks without extending, the fault is more likely in the motor or drive rack rather than the mast itself. Contact us if you need help diagnosing.
Replacing the mast (two people are helpful - one to turn the radio on and off, and the other to work on the aerial)
- Loosen the nut at the top of the aerial mounting until it comes loose. On most universal electric antennas this is what holds the mast in place.
- Turn the radio on (or use the manual switch, if fitted) to fully extend the mast - the mast and drive cable should come completely out. Support the mast so it cannot spring away and hit the vehicle, then carefully slide the old mast off the sleeve coupling (the coupling may remain inside the feed tube, this is okay.
- If necessary, clean the sleeve and inside the feed hole with a soft lint-free cloth moistened with contact cleaner or isopropanol, taking care not to loose anything down it. Do not spray or pour anything inside.
- Fit the new mast onto the same sleeve coupling, making sure it is pushed on fully and seated the same way the old one was.
- Turn the radio off to retract the antenna, you will need to feed the drive cable into the hole, sometimes it will need wiggling around to take. It needs to go into a small hole at the bottom of the feed tube.
- Tighten the mounting nut up securely, but do not over-tighten.
- Turn the radio on again to extend it, checking the new mast runs smoothly through the full travel before closing everything up.
Contact us if you need any help, or think there is another issue inside the aerial itself.