Soundlabs DIN Trim Spacer Mounting Rings for Car Radios

Soundlabs Group DIN Trim Spacer Mounting Rings for Single DIN Mounting of Car Radios

Description:

Four different outer sizes of black textured plastic DIN (standard car radio size) surrounds to give you that nice clean finish and hide gaps. Use the one that is right for your job, or stack them as needed. Helps give your install a professional finish to hide gaps or space your radio as required. Can be trimmed.

Key Features:

• Four Sizes: A range of outside sizes, so you can match the opening in your dash.
• Stackable: Use one ring, or stack them to build up a thicker spacer.
• Can Be Trimmed: Cut or trim to suit your installation.
• Black Textured Finish: A neat, low-key finish that blends in with most dashboards.
• Single DIN Opening: The inside measurement suits a standard single DIN radio.

Typical Uses:

• Hiding gaps around an aftermarket radio where the dash opening is larger than the radio.
• Neatening up a dash that has been cut, repaired or modified.
• Spacing a radio forward when it sits too far back in the dash.
• Giving a custom or universal installation a clean, professional finish.

Outside measurements are as follows:

• Ring 1 (largest): 221 x 92mm approx.
• Ring 2: 208 x 79mm approx.
• Ring 3: 196 x 67mm approx.
• Ring 4 (smallest): 189 x 60mm approx.

Inside measurements are as follows:

• 182.8 x 54.2mm approx. (suits a standard single DIN opening).

Installation Tips:

• Measure your dash opening first, then choose the ring that covers the gap without overhanging the dash.
• Test fit before trimming. Dimensions are approximate, so check against your own dash.
• Stack rings if you need extra spacing or want to build up a stepped look.
• Radio, fascia kit and fixings are not included.