CT Center 200

Art. No. 8445-D

Characteristics - Sound Properties

CT CENTER 200 is based on the CT MAIN 200 main loudspeakers and acts as a Centre Speaker, where the only difference is that it is designed to lie on its side. Since the speaker arrangement and crossover unit are identical in every respect, this centre system is ideal for use with THX® systems. With its linear frequency response of 80 Hz 20,000 Hz in an enclosed cabinet with a total Q-rating of 0.7, the required vertical beaming and a maximum sound pressure of 108 dB, this system leaves nothing to be desired. The loudspeakers used, W 130 SC 4 Ohm and W 200 SC 4 Ohm, are magnetically shielded and the shielding of the complete speaker unit corresponds to THX® regulations (3-Gaussian curve). This means that the entire speaker can also serve as a stand for a TV set. The speaker is a titanium dome tweeter with a Neodymium magnet. The CT CENTER 200 can also be used as a main loudspeaker and, because of its overall dimensions, can be placed on top of a SUB T-40 subwoofer. This speaker has extremely clear bass reproduction with a well-balanced overall sound quality, and impressive spatial separation. High volume settings, particularly important to reproduce live sound, come across powerfully, naturally and undistorted involving the listener directly in the action. The designers placed emphasis on high impedance, so that the speakers can be connected up to virtually any amplifier with no problems. We recommend using this system in conjunction with CT MAIN 200 main loudspeakers, the CT DIPOL 130 effect speaker and the SUB T-40 subwoofer. The virtually perfect reproduction of the sound channels is so close to the original that the listener feels as if they are personally involved in the action. Makes films into an experience.

CT CENTER 200 is part of the combinations:
System CT 200 B
System CT 200 D
System CT 200 E
System CT 200 F

Construction

The cabinet consists of 19 mm boards and a 16 mm thick double baffle. The side panels of the medium range chamber are, at the same time, cabinet stiffeners. It is for this reason that the boards are "T" shaped. First of all, make the necessary cut-outs in the cabinet panels and especially the chamfers on the double baffle. Once the speaker has been completed, cut out the spaces for the woofer and the mid-range drivers. Finally, fit the speakers into the cabinet.

Inner damping

The damping of the speaker uses half a mat of damping material pushed into the medium range cabinet. The remainder is pushed into the bass chamber.

Crossover

Enclosure

Baffle

Mounting SC 4 ND