CT Dipol 100

Art. No. 8416-D

Characteristics - Sound Properties

This dipole speaker makes use of two W 100 S 4 Ohm and two G 25 ND 8 Ohm textile dome units. The idea of dipoles is to create a diffused sound field from the effect channels. For this reason the tweeters at the front and rear are cross-connected. The all-pass circuitry in the deep-bass department ensures that, at frequencies above 200 Hz, the woofers are also cross-connected, and below that level they work in synch. This prevents the bass completely cancelling itself out. The two dipoles should be positioned at both sides of the listening position and just above ear-height or mounted on the wall at that height.

Apart from the CineTOP 100 combination consisting of 2x CT MAIN 100, 1x CT CENTER 100, 2x CT DIPOL 100 and the active subwoofer, it is also possible to combine the Centre and Dipole speakers with small or medium-sized upright speakers such as the ALTO II, ALTO III C or ALTO LINE. As subwoofer, the SUB W-20.39 would be a suitable choice.

CT DIPOL 100 is part of the combinations:
System CT 100 A
System CT 100 B
System CT 100 F

Construction

The cabinet body uses 16 mm boards. First of all, cut the holes in the boards and apply the bevels. This can be done using an electric jigsaw or hand-held circular saw set to the required angle. Once the cabinet has been completed, apply the milling work for the loudspeaker. Finally, fit the cones.

Since the cabinets are relatively small, it is hardly possible to mount the crossover inside the housing. It can, however, simply be wrapped in damping material and placed inside the speaker if the rear wall is not removable.

Inner damping

One mat of damping material is loosely pushed into the cabinet.

Crossover

Sketch

Baffle