CT Center 100

Art. No. 8414-D

Characteristics - Sound Properties

This compact centre speaker will find a suitable space in the shelving just above or below the TV set. It is fitted with two W 100 SC 4 Ohm 's connected in series, which produces a total impedance of 8 ohms. As a result, the CT CENTER 100 can be used in conjunction with receivers that have problem communicating with low-impedance speakers. Up in the high-frequency range, the G 25 ND 8 Ohm, a 25 mm textile dome unit with a Neodymium magnet, performs well. The tweeter is arranged asymmetrically between the woofers in order to achieve an enhanced horizontal radiation pattern. All the drivers are, of course, magnetically shielded to prevent annoying interference effects on TV screens.
Apart from the CineTOP 100 combination consisting of 2x CT MAIN 100, 1x CT CENTER 100, 2x CT DIPOL 100 and the active subwoofer, it is also possible to combine the Centre and Dipole speakers with small or medium-sized upright speakers such as the ALTO II, ALTO III C or ALTO LINE. As subwoofer, the SUB W-20.39 would be a suitable choice.

CT CENTER 100 is part of the combinations:
System CT 100 A
System CT 100 B
System CT 100 C
System CT 100 D
System CT 100 E
System CT 100 F

Frequency response

Construction

The cabinet body uses 16 mm boards. First of all, cut the holes in the boards and apply the bevels. This can be done using an electric jigsaw or hand-held circular saw set to the required angle. Once the cabinet has been completed, apply the milling work for the loudspeaker. Finally, fit the cones.

Since the cabinets are relatively small, it is hardly possible to mount the crossover inside the housing. It can, however, simply be wrapped in damping material and placed inside the speaker if the rear wall is not removable.

Inner damping

One mat of damping material is loosely pushed into the cabinet.

Crossover

Sketch