Silver Wire 0.15mm

99.99% pure silver wire from Audio Consulting in Switzerland.

Note: Wire is sold and priced per metre. For longer lengths, change the quantity in the shopping cart.

Use this 0.15mm solid core insulated silver wire to make or upgrade existing wiring and cables. The 0.15 mm solid core silver wire is suitable for digital interconnects and tone arm wiring.

The polyesterimide insulation has to be as thin as possible to help stop dielectric absorption and electrostatic micro-discharges.

Typical Applications:

Interconnects
For digital interconnects, it is preferable to use the 0.15 mm silver wire. For digital cables six runs of the 0.15 mm silver wire per polarity is excellent but less can be used. Put each polarity in 2 mm cotton, then the whole set-up in a single 9 mm cotton sleeve.

To make a very high performance interconnect, the 0.5 mm silver wire is recommended.

Rewiring

CD / SACD Players, DACs, turntables, phono arms etc, can all be rewired to some extent. For digital signals try several runs of 0.15 mm in parallel, 5-6. Cotton sleeving will be an advantage. The ground also should be of the same topology.

Tonearms
Tone arms make for excellent candidates for the silver wire treatment! Use one run per pole of the 0.15 mm silver wire; it is very close is size to 33 AWG wire. If you want to experiment, try extra runs per pole, in fact Audio Consulting use 6 runs per pole in their own arm!

Grounding
The star grounding system: take as many wires as you have ground connections. With a butane flame, melt all of them together at one end. All connections go with one wire to this single point, which becomes the perfect star grounding.

Important
As with all types of wire, you must be careful not to exceed the allowable current for this diameter of wire. Multiple runs may be used to increase the current carrying capacity if required. The silver wire has been used up to about 30-40 VDC without any further insulation. The enamel should be good for a few hundred volts, but this has not been tested. We do not recommend that this wire be used for high voltages applications without appropriate insulation and precautions in place.

Since the silver wire is insulated with a polyesterimide coating, this will have to be removed before any soldering can take place. It can easily be done by scraping with a sharp knife, taking care not to make any kinks in the wire or by burning off with a flame.

Additional cotton sleeving not only increases isolation, but can can also improve the sound, even for internal wiring of electronics and even in the power supply.

Solid Core Silver Wire Data:

• Diameter: 0.15 mm (external: 0.17 mm); 35 AWG
• 99.99% Ag (Silver)
• Polyesterimide enamel insulation
• DC resistance: 0.95 Ohms/metre (0.15 mm)

Note: Wire is sold and priced per metre. For longer lengths, change the quantity in the shopping cart.